In the development of modern science and technology, practical machinery has become an important role in the development of mankind. Especially in the transportation of raw materials for construction and mines, human transportation alone is extremely laborious and efficient, and extremely dangerous! The small fine stone concrete pump produced by TALENET completely solves this problem for users! The main advantages of this series of fine stone concrete pumps are low noise, simple operation, convenient movement, compact structure, high pressure, high lift and so on.
 
Maintenance method of concrete pump:

1. First, the lubricating oil in the bearing housing should be replaced regularly, usually every 6 months under normal conditions.

2. Secondly, keep no traces of water on the motor to prevent the motor from being damp, which will affect the use and safety of the equipment.

3. In cold season, if there is icing phenomenon after the pump is stopped, the cooling water at the seal should be connected first, and the water can be heated to defrost if necessary, and then turn the coupling by hand until it runs flexibly, and then drive according to the starting steps.

4. For the pump with cooling water device, the cooling water should be connected before driving. When the pump is running normally, it can continue to be connected, or it can be stopped if conditions do not permit it.

5. The operation of the pump when the outlet valve is closed is called closed pressure operation. The closed pressure operation time of all-plastic pumps or plastic-lined pumps should be shortened as much as possible. The normal temperature medium should not exceed 5 minutes, and the high temperature medium should not exceed 2 minutes.

6. Finally, the pump cannot bear the weight of the inlet and outlet pipes. The shorter the inlet pipe is, the better. The vertical height from the pump outlet to the valve should be as short as possible.